How to Use a Power Drill – A Basic Guide

Woman using hand drill to assemble a wooden table

If you’re looking for how to use a power drill, then chances are you’ve been interested in the power of drilling holes with relative ease.

It’s a basic drill and you use one or more rotating shafts to drill into surfaces. You can drill into metal, wood, concrete, ceramics, plastics, and pretty much anything else with relative ease. It’s just the basic principle of the drill.

Tip #1

The first thing you have to know about a power tool is how you can change out the bits. Most modern high-powered drills tighten by means of compression.

Here s how it operates: The larger the diameter of the bit, the harder it is to spin. The smaller the diameter, the easier it is to spin. Since the drill bits get harder as the diameter gets bigger, that is something you’ll notice.

To change out bits, remove the power drill from the work area and unscrew the bit from its slot with a screwdriver or chisel.

Some types of drill bits require special holders that hold them in place while they are being rotated. If this is the case, then unscrew the bit from its slot and use a screwdriver to remove the screws.

Remove the bit from the holder and discard. Note which side of the screw is on so that you can put the new bit in the same way.

Tip #2

Some of the other things you have to keep in mind when learning how to use power drills are: how to hold the tool upright (or horizontal), and how to drill in straight lines, not verses or circles.

If you hold the power drills sideways, you might hit your toe or your finger if the drill bit is not centered straight.

When drilling in straight lines, use both hands for balance. Keep in mind that drilling in a counterclockwise motion will cause a “clicking” noise because of the rotation of the bit.

Tip #3

In addition, when learning how to use a power drill, one of the most important things to remember is that the chuck should be used in conjunction with the drill.

A good chuck should provide sufficient power to drive the drill into the wood, but should also have a limit as to how far it can drill before the chuck runs out of power.

When the chuck is already driving into the wood, it needs to have enough torque on the handle so that it can start the drilling motion again without striking the wood with the chuck. Most drills come with a pre-mounted chuck, but some drills require specific attachments or else can only be installed with after-market accessories. These accessories include an air clamp or a hydraulic chuck arm.

Why You Should Have a Power Drill

The uses for a power drill at home are many. It can be used to quickly and efficiently remove small pieces of wood, nails, or plastic from the walls and furniture in your home.

This device is also very handy when making repairs to anything in your home, whether its a door or window, and even repairing broken appliances or your car. It can also be used to help you nail down the doorknob on your door without having to pound it in.

If you’re a handyman type or just enjoy doing small home improvement projects, then you’ll be able to benefit from the power of a power drill.

The best thing about these home improvement tools is that they don’t require you to spend a lot of money to purchase them or to learn complex installation procedures.

You can buy a portable one for less than $30, and it is a good idea to have a couple of them around if you want to perform several small home improvement projects at once.

 

 …